[. . . ] Operator’s manual (EPA) 323HD60 325HD60X-series 325HD75X-series Please read the operator’s manual carefully and make sure you understand the instructions before using the machine. English KEY TO SYMBOLS Symbols WARNING!Incorrect or careless use of a hedge trimmer can turn it into a dangerous tool that can cause serious or even fatal injury. It is extremely important that you read and understand the contents of this operator’s manual. The engine is switched off by moving the stop switch to the stop position. [. . . ] Be aware of the fire hazard, especially when working near flammable substances and/or vapours. • • Clean the area around the fuel cap. Ensure that the fuel is well mixed by shaking the container before filling the tank. ! English – 11 STARTING AND STOPPING Check before starting Starting and stopping • • Inspect the working area. The complete clutch cover and gear housing must be fitted before the machine is started, otherwise the clutch may come loose and cause personal injury. Always move the machine about 3 metres from the refuelling position before starting. Remember that the blades may start to move when the engine is started. Make sure that no unauthorised persons are in the working area, otherwise there is a risk of serious personal injury. The safety distance is 15 metres. • • • • • Check that the machine is in perfect working order. Check that the cutting attachment always stops when the engine is idling. Make sure that the handle and safety features are in good working order. Never use a machine that lacks a part or has been modified outside its specifications. All covers must be correctly fitted and undamaged before you start the machine. Cold engine Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. • Choke: Set the choke control in the choke position. A Warm engine Primer bulb: Press the air purge repeatedly until fuel begins to fill the bulb. The bulb need not be completely filled. 12 – English STARTING AND STOPPING Starting Hold the body of the machine on the ground using your left hand (CAUTION!Grip the starter handle, slowly pull out the cord with your right hand until you feel some resistance (the starter pawls grip), now quickly and powerfully pull the cord. Push the choke control back to its original position as soon as the engine fires, and continue trying to start until the engine starts. Do not pull the starter cord all the way out and do not let go of the starter handle when the cord is fully extended. This can damage the machine. Stopping The engine is switched off by moving the stop switch to the stop position. CAUTION!In order to prevent unintentional starting, the spark plug cap must be removed from the spark plug when assembling, checking and/or performing maintenance. English – 13 WORKING TECHNIQUES General working instructions IMPORTANT!This section takes up the basic safety precautions for working with a hedge trimmer. If you encounter a situation where you are uncertain how to proceed you should ask an expert. • Never work from a ladder, stool or any other raised position that is not fully secured. Safety instructions while working !Hold the machine in front of your body. Personal protection • • • • • Wear personal protective equipment. [. . . ] Check and clean the spark arrestor mesh on the muffler (only applies to mufflers fitted with a catalytic converter). Clean dirt, leaves and surplus lubricant, etc from the muffler and engine. X X X X X X X X X X X X X X X X X X Check that the hand guard is not damaged. X 20 – English TECHNICAL DATA Technical data Technical data Engine Cylinder displacement, cu. in/cm3 Cylinder bore, inch/mm Stroke, inch/mm Idle speed, rpm Recommended max. [. . . ]